Professional video over IP systems use some existing standard video codec to reduce the program material to a bitstream (e.g., an MPEG transport stream), and then to use an Internet Protocol (IP) network to carry that bitstream encapsulated in a stream of IP packets. This is typically accomplished using some variant of the RTP protocol.
Carrying professional video over IP networks has special challenges compared to most non-time-critical IP traffic. Many of these problems are similar to those encountered in voice over IP, but to a much higher level of engineering requirements. In particular, there are very strict quality of service requirements which must be fulfilled for use in professional broadcast environments.
Maps, Directions, and Place Reviews
Packet loss
Since even well-engineered IP networks tend to have a small residual packet loss rate caused by low-probability statistical congestion events and amplification of bit errors in the underlying hardware, most professional solutions use some kind of forward error correction to ensure that the encoded video stream can be reconstructed even if a few packets are lost. This is typically applied at the packet level, since the encapsulated video bitstream is typically only designed to tolerate low levels of bit or burst errors, rather than the loss of whole packets. Resending packets is not an option because of the sequential nature of the underlying video signal. For live video, a resent packet would arrive well after the arrival of the next frame of video.
Professional Video Services Video
Network delay variation
Network delay variation can be kept to a minimum by using a high-speed network backbone, and ensuring that video traffic does not encounter excessive queue delays. This is typically done by either ensuring that the network is not too close to its full capacity, or that video traffic is prioritized using traffic engineering techniques (see below).
The remaining delay variation can be removed by buffering, at the expense of added time delay. If forward error correction is used, a small proportion of packets arriving after the deadline can be tolerated, since they can be dealt with by being discarded on receipt, and then treated in the same way as lost packets. Added time delay is particularly unwelcome in PTZ cameras as it makes operator control difficult at values over 250ms.
Timing reconstruction
The other problem presented by latency variation is that it makes synchronization more complex by making the recovery of the underlying timing of the video signal far more difficult. This is typically solved by genlocking both ends of the system to external station sync signals, typically generated from sources such as GPS or atomic clocks, thus only requiring the extraction of coarse timing information at the receiving end in order to achieve high-quality video synchronization. The extraction of coarse timing data is typically done using a phase locked loop with a long time constant.
Adequate bandwidth
Even with packet loss mitigation, video over IP will only work if the network is capable of carrying the content with some reasonable maximum packet loss rate. In practice, this means that video over IP will not work on overloaded networks. Since IP does not of itself offer any traffic guarantees, this must be applied at the network engineering level. One approach to this is the "quality of service" approach which simply allocates sufficient bandwidth to video-carrying traffic that it will not congest under any possible load pattern. Other approaches include dynamic reduction in frame rate or resolution, Network Admission Control, bandwidth reservation, traffic shaping, and traffic prioritization techniques, which require more complex network engineering, but will work when the simple approach of building a non-blocking network is not possible. See RSVP for one approach to IP network traffic engineering.
The Pro-MPEG Wide Area Network group has done much recent work on creating a draft standard for interoperable professional video over IP.
Use by Security Industry
Within the security products industry, IP-based Closed Circuit Television (CCTV) is making gains on the analog market. Key components of IP-based CCTV remain consistent with analog technologies: image capture, with a combination of IP-based cameras or analog cameras using IP-based encoders; image transmission; Storage and Retrieval, which uses technologies such as RAID arrays and iSCSI for recorded and indexed video; and video management, which affords web browser-enabled management and control of IP-based CCTV systems.
One key advantage of IP-based CCTV is the ability to use network infrastructure, providing adequate bandwidth and availability of switching and routing, rather than coaxial cabling. However, running bandwidth-intensive surveillance video over corporate data networks is a point of organizational contention, depending on the potential impact on network performance.
A class of companies produce Video Management Software to help manage capture and storage of video content. Digital video also makes possible Video Content Analysis, which allows automatic detection and identification of various kinds of objects or motion.
Also another emerging model is off-site storage of surveillance video. These online surveillance providers are utilizing cloud computing technologies to consolidate multi-site surveillance video over the web.
Manufacturers of CCTV equipment are steadily integrating IP network technology into their product portfolios.
Compare with
- Professional video over ATM
- DTM
Source of the article : Wikipedia
EmoticonEmoticon